I decided to make a sample before plunging into making a seat cushion. I decided this for 2 reasons. First, I am not sure where most of the batts are hiding, so I only had a small batt handy. Second, I needed to do some quick felting for the blog today. The sample fit the bill perfectly.

This is a Swiss Mountain batt. I got it off Etsy a few years ago.

I decided 10 inches by 10 inches is a good size for a sample and makes shrinkage easy to calculate. Please excuse my dirty-looking table; it’s some sort of glue that won’t come off.

The edges a thin, so I folded them down to make it square.

I added a layer going up and down.

Once it was wet down, I folded the thin edge top and bottom to square it to 10 inches. That would have been enough to make a sample, but it would also be very boring.

I got out some balls of my handspun and made a spiral. Who doesn’t like a spiral?

I spent longer than normal rubbing so the yarn would stick without moving too much. My impatience usually results in wobbly lines.

Then, of course, lots of rolling to full it properly.

The finished sample ended up just about  7 by 7 inches

It ended up fairly sturdy. The spiral ended up holding its shape very well. However, it is quite hairy and I think it would be a bit prickly to sit on with thin pants or a dress. Once it is dry, I will try shaving it, but I don’t think it will work. There will still be short, strong fibres on the surface. I may have to try some Blue-faced Leicester or maybe some Corriedale. What’s your favourite strong wool for sturdy applications?