Browsed by
Tag: nuno felt as surface design

Finished Scarves

Finished Scarves

Comments 10 comments

I managed to finish the 2 scarves I was working on,  They are now dry and ironed.

This is the white one. It is nuno felt down the middle. I had wanted to put black locks on the ruffles but what I thought were black locks are purple and they bled when I tested one.  So not going on a white scarf.

Here’s a close up of the end with the white locks. They are Bluefaced Leicester locks.

Here is the red one. No close-up, it just bounced a red blur into the camera.

They are a bit of a nuisance to iron. you have to do the edges one at a time, separately from the center. It looks like this when you are ironing.

This is what they look like rolled up, like fancy dumb bells. It does keep the ruffle snice though.

I did mange to get 3 more done this week. I finished them today. They are hanging in the bathroom drying so no pictures yet.  I did start a new one and forgot to take a picture of it until I was wetting it down.

and a close up of the lace and the end. This fabric came from an odd-looking little poncho. I can’t remember where I got it but it must have been part of an outfit. You can see the silk fibres I added to the edge in the first picture. The second picture is when it was flipped over so I could neaten up the edges. the finished edge of the fabric will look really nice sticking over the end I think.

More pictures next week and I hope, at least one finished hat. Hats are tomorrow’s job.

Facebook Event    Web page

Guest Blog Post – The Bird And His Breakfast

Guest Blog Post – The Bird And His Breakfast

Comments 21 comments

This is a guest post by Lyn of Rosiepink. She created a wonderful piece for the Second Quarter Challenge. Thanks Lyn!

The second quarter challenge is to use fabric as a surface design instead of a base, so
out came my boxes of fabric! Spring has come to my garden and it’s a welcome sight after the winter, so what better place to find inspiration for my challenge piece – the bird and his breakfast.

First I drew a bird. It’s not accurate, anatomically speaking, but I like its quirkiness.

After a lengthy rummage through my fabric stash – and finding lovely pieces I’d
forgotten all about – I chose two very open weave fabrics for the background and the
bird so that the nuno felt would end up flat rather than ruched…

…then I made two pieces of nuno felt using four fine layers of white merino wool under
each piece of fabric.

The brightly coloured fabric was a triangle, so I cut it in half and placed the two pieces
together to make a square to make the felting easier – you can see the cut in the photo
above.

Both pieces of nuno felt needed a light shave to remove the superfluous white fluff from
the surface to reveal the bright colours. You can see the white fluff obscuring the colours in this angled shot…

…and here’s a close up of pre and post shave – quite a
difference.

The bird has 12 distinct shapes within its form, so I used the drawing as a pattern to cut
12 shapes from the brightly coloured felt when it was dry.

Using the side of a dark blue ‘Sharpie’ pen point, I touched along the edges of every
shape to give a little definition. I coloured in the eye, using the same pen, then added
three small white stitches for the eye-glint.

I needle felted the pieces into place – it was a bit like doing a jig-saw! I didn’t go too
close to the edges of the nuno felt shapes because I thought it might disturb the surface
too much. I needle felted gently so that the shapes adhered to the background but didn’t flatten, so the bird is in relief.

The worm is wool yarn needle felted into place. The piece of worm going from the
ground to the beak is thin compared to the bit hanging from the bird’s beak to show how
stretchy worms can be!

Great post, thanks Lyn!

%d bloggers like this: