Recently we have acquired a new bookcase for our living room. It was actually made to fit in the space between the front wall and the door of the room. However it has a sort of lip around the top, the corner of which was banged by the glass of the open door if we were not careful.
Obviously we needed something to stop the door before it fully opened. After some thought I decided that it needed to be tall (so that we didn’t have to bend down too far to move it – the floor gets further away the older you get), but it needed to be thin too otherwise the door wouldn’t open far enough to let one of us safely into the room, especially with drinks in hand.
I wanted it to go with the colour of the carpet and I knew that I had somewhere in my stash a blue wool sweater that I had felted (on purpose) by putting it through the washing machine. I finally rooted it out and decided that I would use one of the sleeves, which had a pattern knitted into it.
Initially I thought that I would make a tall thin pyramid shape to fit in the gap between the side of the book case and the door. I sewed up the cuff of the sleeve and, to make sure it didn’t keep falling over, I begged a piece of flat lead sheet from my husband which I fitted into the bottom of the stuffed sleeve, and then sewed up what had been the shoulder to make the base.
Well it was ok, but I thought it needed a bit more interest and decided to turn the door stop into a cat.
Out came the felting needles and my scoured merino, which I use as core fibres. Then for the “top coat” I sorted through the blues in my stash – normally jealously guarded because I don’t have a lot now as I use them for sky in my pictures – and found some which almost matched the main blue of the sleeve. Obviously he wasn’t going to be a realistic cat so I tried to “cartoonise” his features, and rather than give him needle felted eyes as I might normally do I fished out some bright orange glass eyes from another stash which would go well with his dark blue face. I used some of the blue to make a wet felt sheet, out of which I cut his ears.
Having made his head, I attached it to the tall thin pyramid. It’s sewn as well as needled on, but even so I was concerned that if he was picked up by his head it might come off. I made a piece of blue cord and attached that as a loop behind his head so that he might be moved safely. And here we have him.
Not long after this, we acquired a new pinky-grey bathroom carpet and also new pink and grey towels to replace very tired old red ones. Until then we had been using the bathroom scales as a door stop – that door will slam very hard if the wind gets up when the window is open. So now I decided that we would need another door cat.
When we got the new carpet we did not change the basic colour scheme as we didn’t want the hassle of changing the suite (vintage Pampas) or the tiles. The colour scheme is essentially derived from the tiles, which are pink and grey with some crimson detailing. Originally we had a red-ish carpet and red and dark grey towels, but when I bought those towels I could not get a bath mat to match, so I made one by stitching two red hand towels back to back.
As the new carpet shed fibres quite a lot to begin with I thought of making the new door cat out of that fibre, but after a little more thought I realised that that would not be a good idea. We would keep falling over a camouflaged cat in the gloom of a late night visit!
So I thought I might find another felted sleeve, but couldn’t come up with something the right colour. Then, because we still had touches of red in the room, I decided that I would deconstruct the old red bath mat and use one of the pieces for the cat’s body. I had already given away the rest of the old towels to my friend for her dogs.
I felt that a “loaf cat” pose would be best, less likely to tip over if the wind caught the door, but I’d need too much lead sheet to make it a suitable weight. So I visited the garden and found a triangular(ish) shaped piece of rock, washed it and wrapped it in a couple of layers of non-woven cotton towels, secured with masking (painter’s) tape. I made myself a paper pattern of the body and cut out two body sides and a gusset for the base and chest. I cut out the pattern pieces from the towel and stitched it all up (first inserting the wrapped rock and stuffing it with polyester stuffing.
I had seen a cartoon of a smiling cat, which had enormous ears, which looked really cheeky. I thought I’d have a go at making one like that. I started with the core fibre again and got the head substantially how I’d like it and then thought about fibres for the coating.
I did not have exactly the right red, so had to blend a couple of pieces of pre-dyed merino tops which seemed to work ok. I did the same to make a pinky-grey blend for the chest, face and inside of the ears. I had decided that I would make the cat’s chest a similar colour to the carpet which meant that I had to make a wet felted sheet of the pinky-grey batt to cover the original red towelling. I cut the felt into the shape of the chest gusset, leaving enough for a pair of large ears.
I needled some of the red onto the back of the ears, and this resulted in a darker pink on the inside where the needles had pushed fibres right through, which was actually a benefit I think. I needled the blended red on to the back of the cat’s head and neck, and the pinky-grey onto the face, attached the ears and gave him a darker pink nose. I “shadowed” the smile and blinking eyes and I also gave him some laughter lines.
Then I stitched the head onto the neck, and the chest piece over his front, catching in the head at the neck. I covered the join with more needled fibres and, using another piece of towel, attached a handle to the back of his neck so that he could be moved without his head coming off.
My husband has already named him Yoda. We each confessed the other day that we both chat to him (in fact I pick him up and cuddle him too – he just fits into one arm)
What about the poor tatty sheep at the beginning of this post? Well, many years ago now, when I was a fairly new needle felter, I decided that I’d like to make myself a door stop for my bedroom door. I had acquired from our Guild a Jacob fleece, which, as it turned out, was ideal for needle felting. It certainly wasn’t a lot of good for wet felting – it wouldn’t, whatever I did to it. I suppose I must have had an old ram’s coarse and kempy fleece palmed off on me, when I was too naïve to know what I was getting – no wonder it was cheap!
Anyway, I got a body shaped pebble out of the garden, and washed it, wrapped it in some of the un- wetfelted fleece and started in with a No.36 felting needle (I only had 36 triangle and 38 star needles in those days- oh and a No.19 which was so thick it wouldn’t really go through anything I had with any ease). I bust quite a few needles before the pebble was covered. I added a neck to one end and then decided that my sheep would need eyes and a pair of horns. At that time I did not know that Jacob sheep often have 4 horns and wear them as if they had put them on in a hurry in the morning whilst still half asleep!
I made the horns and eyeballs using pipe cleaners and white Fimo polymer clay, baked and painted with acrylic paints. At that stage in my career I had not thought of using PVA glue on needled fleece to make horns. I needled a head shape around the horns and eyes, and then attached it to the neck. It did not occur to me to strengthen the neck with the ends of the pipe cleaners, I had cut these short and just put the horns on either end, and did the same with the eyes.
Well it all worked and for years he sat by my door, getting moved when necessary with my foot. Now he’s a sad old thing, but being sentimental I can’t bear to get rid of him, even though he’s lost a horn and is definitely the worse for wear. Perhaps I’ll give him a “makeover” sometime.