I’ve mentioned recently that I don’t have the space to do any felting at home at the moment. Well, my last post about Textured Felt reminded me that I don’t need the time/space to do the wet felting part as long as I can do the layout and find the time for stitching. So, a couple of days ago I started to ‘build’ a textured felt vessel. I used all natural wools, animal fibres and embellishments. For the texture scraps between layers, I used some unravelled wool knitting. I don’t know if it’s 100% wool. I found the time to do the layout, stitching and unpicking, but that’s as far as I’ve got so far. I did two ‘regular’ thickness layers on each side and two ‘half layers’, basically 3 layers but split one into 2 for even shrinkage. I didn’t put texture between the two ‘half’ layers. This is the top with a hole cut and the resist taken out:

This is what it looks like when I separate the layers to make it more 3D:

This is how the bottom looks ‘flat’:

And separated/3D:

There is quite a thick ‘edge’, I thought putting the resist on top would show how much, but I’m not sure it’s that obvious:

I used a fine ‘layer’ of raw/unwashed uncombed Huacaya Alpaca beneath the top layer of locks and embellishment fibres. You can see how fluffy it is:

I put lots of locks around the edges:

Here are some Bluefaced Leicester locks:

I still haven’t found time or space to finish off my coiled pot, but since I was taking photos today, I thought I’d get a couple that show the texture. This is the bottom:

And the side:

Hopefully, by my next post, both of these will be finished.