If you are on the forum you may have seen the resist for this hat in the daily dose of fiber thread for this month. daily-dose-fiber-october-2017

I used wool in 3 layers because I wanted most of the shrinkage to be around. I wanted some height to play with.

After I cut it open I worked the edges and the rest as normal but near the end I also cut the top part of the right hand curled brim. I worked those edges to get them sealed. the rinsed all the soap out and let it dry because I was out of time for a few days. Today I finally got some time to work on it some more. I wet it all down and popped it onto a regular hat block and twisted the two long cut pieces around each other and then curled the ends around some tiny “pool noodles” I over exposed the picture trying to get the twist to show but the wool is just to dark.

Then I put in two sloped folds and pinned them with the little double pins. I found them after spending half an hour trying to fined my T pins that I gave up on finding. I am sure they are somewhere that was logical at the time but isn’t any more. I am not sure how that happens but it happens to me all the time.

It is now drying. The hat is sitting on another flat toped hat block and the pop bottle is holding the rim up so it dries in a better position.

When it is all dry I will take a picture of it again and show it to you.

Have you been working on any new designs lately?