We’ve been working away on the yurt since my last post. We finished drilling all the holes and then  there was a scare because I figured out that I had cut all the pieces the wrong size. I had thought something was wrong when we were drilling the holes and the last one was right at the end of the board. So I looked back at the book and the length was supposed to be 78″. I had cut them to 7′ long. Luckily, that means they are supposed to be 6.5′ long. So they were too long. But that’s much better than too short. So I cut them all down to 6.5′ long. Next up, sanding.

Just to be clear, we are making what is called a Mongolian ger. The word ger rhymes with air. Mongolians do not call their dwellings yurts. But since most people know these type of dwellings as yurts, I think it will be simpler to keep calling it a yurt.

When I wrote my last post, Ann had suggested that I use a stationary belt sander. We have a hand-held one but not a stationary one. So Dennis rigged up a way to use the hand-held sander upside down. It is clamped on to a piece of plywood on a saw horse.

The small piece of wood on the right hand side of the photo is used to keep the sander button pushed down. Normally, you have to hold it down the entire time you are sanding. But that wouldn’t work in this position. So the wood holds the button down for me. I’m sure this whole process is not the way you are supposed to use a belt sander. Perhaps I should have a warning of “Don’t try this at home.” 🙂

So here I am sanding a wall rod. It takes between 5-7 minutes to sand one rod and I only have 110. I’ve done 20.

This really does make the sanding much easier. Thanks Ann for your idea. It works perfectly.

I even sand the ends. I want everything to be nice and smooth before we paint the rods. I am wearing ear protection and my glasses but next time I am going to wear a mask. The sander puts all kinds of saw dust into the air.

Next, I have to figure out how to put the walls together. I laid out the boards and the middle ones make perfect sense. It’s just when you get to the ends, that you have to figure out what part of the boards need to be cut off and in what direction.

As you can see, the edges are not right because I haven’t cut the boards shorter. The book says we need 8 up (6), 8 down (6), 7 up (3), 7 down (3) etc. After laying the boards out, I think I have it figured out but I really don’t want to cut them wrong. So I guess I’ll do one wall first so I don’t cut them all wrong. So it’s just a bit confusing and being easily confused doesn’t help the matter! There will be four wall sections when we’re finished. Wish me luck!

After I get one wall section completed, I can begin the felting process. I need to know the exact dimensions that need to be covered before I can make the felt walls. I would hate to do all this work and end up with the wrong size. So felting will begin soon, I promise.